Description

Style your Porsche with The Best Damn Decals from Rumble Wraps!

Introducing our signature series: Heritage. Designed and digitally cut to exacting specifications, these OEM quality professional grade decals are the unparalleled choice for retro-styling your overlanding, offroad, and race vehicles. Paying homage to vintage designs, our Heritage line gives you the custom look you want in an easy-to-install kit. These films resist peeling and fading and boast an outdoor like of 7-10 years on vertical surfaces.These professional grade films allow for easy installation over 3-D shapes and cutouts. The wet installation method allows for a stress free install and professional finish. All Heritage products come with topsheet that can flex and breathe with the vinyl providing superior scratch protection during installation.

Installation Guidelines FOR PORSCHE:

• Professional installation is required for all products
• Installation area should be temperature controlled at 68-72 F
• The installation area should be enclosed, clean, well lit, and dust free. Installation should never be done outdoors. 
• Vehicle should be washed and cleaned thoroughly removing any and all contaminants on general areas where decals will be installed. Extend cleaning 6-12 inches beyond the area of decal installation and clean thoroughly above the graphic area to avoid contaminants falling down into vinyl during installation. 
• Final prep should be done with 70% isopropyl alcohol or 3M Adhesive remover. Clay bar detail if necessary to remove stubborn contaminants.
• Never attempt installation without the proper tools. Click here to purchase our installation kit (***Sade- we can leave the link out for now)
• All decals will be installed using a slip solution. This mixture should consist of: 4-5 large drops of dish soap or baby shampoo in 32 oz water. Alternatively RapidTac or similar solution may be used. Increase or decrease slip depending on your install experience.
• Squeegee technique must be as follows: Soft to medium pressure during initial pass to secure graphics into place. Apply firm pressure for second pass at 45 degree angle overlapping strokes 25-50%. Thoroughly press all fluid towards outer edges. Squeegee in columns or rows to avoid bubbles. Ensure thorough contact of adhesive on the entire decal.
• Remove topsheet line using proper technique: peel at 45 degree angle when possible at extremely low profile (backrolling against vehicle). Peeling at high lift angle can result in creating unnecessary bubbles or weakening the adhesive bond and can cause decal failure. Please allow decals to cure for 10min to 1 hour before peeling topsheet.

Cleaning Guidelines:

• Hand wash gently with pH balanced car wash soap. 
• Ceramic Coatings may be applied, however coatings are NOT warrantied by Rumble Wraps. Rumble Wraps is not responsible for any issues that may arise from your ceramic coating your decals. 
• Do not apply wax to matte or satin finishes. 
• Ceramic booster detailing sprays can be applied after wash. Rumble Wraps is not responsible for any issues that may arise from you applying detailing products to your decals.