Description

Style your FORD BRONCO with The Best Damn Decals from Rumble Wraps!

Introducing our most affordable series: Blackout. Machine cut from 3M Matte Black or 3M Satin Black 3M 2080 vinyl, the professional grade decals are simple and effective. These professional grade films allow for easy installation over 3-D shapes and cutouts. The air release feature allows for bubble free installation. All Blackout products come with topsheet that can flex and breathe with the vinyl providing superior scratch protection during installation.

Installation Guidelines FOR FORD BRONCO:

• Professional installation is required for all products
• Installation area should be temperature controlled at 68-72 F
• Installation area should be enclosed, clean, well-lit, and dust free. Installation should never be done outdoors. 
• Vehicle should be washed and cleaned thoroughly removing any and all contaminants on general areas where decals will be installed. Extend cleaning 6-12 inches beyond the area of decal installation and clean thoroughly above the graphic area to avoid contaminants falling down into vinyl during installation. 
• Final prep should be done with 70% isopropyl alcohol or 3M Adhesive remover. Clay bar detail if necessary to remove stubborn contaminants.
• Never attempt installation without the proper tools.
• All decals will be installed using the hinge or band-aid technique, using tape or magnets to make the graphic stationary in the center and installing one side first, then the other. 
• Squeegee technique must be as follows: Softer pressure during initial pass to secure graphic into place. Apply firm pressure for second pass at 45 degree angle overlapping strokes 25-50%. Thoroughly press all air towards outer edges. Squeegee in columns or rows to avoid bubbles. Ensure thorough contact of adhesive on the entire decal.
• Remove topsheet line using proper technique: peel at 45 degree angle when possible at extremely low profile (backrolling against vehicle). Peeling at high lift angle can result in creating unnecessary bubbles or weakening the adhesive bond and can cause decal failure.

Cleaning Guidelines:

• Hand wash gently with pH balanced car wash soap. 
• Ceramic Coatings may be applied, however coatings are NOT warrantied by Rumble Wraps. Rumble Wraps is not responsible for any issues that may arise from your ceramic coating your decals. 
• Do not apply wax to matte or satin finishes. 
• Ceramic booster detailing sprays can be applied after washing. Rumble Wraps is not responsible for any issues that may arise from you applying detailing products to your decals.

WATCH INSTALLATION VIDEO